Feature w103 potentiometer
This small trimpot w103 potentiometer potentiometer is used to calibtrate circuits by adjusting the value of resistance in the circuit. Trimmer potentiometers require a screwdriver to change the value of resistance and are not indended to by adjusted often such as by the user of the device.
Once you have set your resistance value then you will generally leave the trimmer potentiometer at that value indefinitely.
Electrical Characteristics Standard Resistance Range to 2 Megohms (see standard resistance table) Resistance Tolerance: f10%std. (tighter tolerance available) Absolute Minimum Resistance: or 2 ohms max. (whichever is greater) Contact Resistance Variation or 3 ohms max. (whichever is greater) Adjustability Voltage f0.05% Resistance f0.15% Resolution: Infinite Insulation Resistance 500 vdc 1,000 Megohms min. Dielectric Strength 101.3 kPa 500 vac 8.5 kPa 315 vac Adjustment Angle: 210enom.
Environmental Characteristics Power Rating (250 volts max.) w103 potentiometer 0.5 watt , 0 watt (125) Temperature Range to +125 Temperature Coefficient: f100ppm/ Vibration: m/s2 (1%TR;2%VR) Shock: (1%TR; 1%VR) Load Life 1,000 hours 0.5 watt or 4 ohm ) Rotational Life: 200 cycles or 4 ohm,) Physical Characteristics Mechanical Angle 250° nom. Torque 20 mNgm max. Stop Strength 50 mNgm min. Terminals Solderable pins Standard Packaging 50 pcs. per tube
This legal disclaimer applies to purchasers and users of Bourns products manufactured by or on behalf of Bourns, Inc. andits affiliates (collectively, “Bourns”).Unless otherwise expressly indicated in writing, Bourns products and data sheets relating thereto are subject to changewithout notice.
Users should check for and obtain the latest relevant information and verify that such information is currentand complete before placing orders for Bourns products.The characteristics and parameters of a Bourns product set forth in its data sheet are based on laboratory conditions, andstatements regarding the suitability of products for certain types of applications are based on Bourns’ knowledge of typicalrequirements in generic applications.
The characteristics w103 potentiometer and parameters of a Bourns product in a user application may varyfrom the data sheet characteristics and parameters due to (i) the combination of the Bourns product with other componentsin the user’s application, or (ii) the environment of the user application itself. The characteristics and parameters of a Bourns product also can and do vary in different applications and actual performance may vary over time.
Users should always verifythe actual performance of the Bourns product in their specific devices and applications, and make their own independentjudgments regarding the amount of additional test margin to design into their device or application to compensate fordifferences between laboratory and real world conditions.
Unless Bourns has explicitly designated an individual Bourns product as meeting the requirements of a particular industrystandard (e.g., ISO/TS 16949) or a particular qualification (e.g., UL listed or recognized), Bourns is not responsible for anyfailure of an individual Bourns product to meet the requirements of such industry standard or particular qualification. Usersof Bourns products are responsible for ensuring compliance with safety-related requirements and standards applicable totheir devices or applications.
Bourns products are not recommended, authorized or intended for use in nuclear, lifesaving, life-critical or life-sustainingapplications, nor in any other applications where failure or malfunction may result in personal injury, death, or severe propertyor environmental damage. Unless expressly and specifically approved in writing by two authorized Bourns representativeson a case-by-case basis, use of any Bourns products in such unauthorized applications might not be safe and thus is atthe user’s sole risk.
Life-critical applications include devices identified by the U.S. Food and Drug Administration as Class IIIdevices and generally equivalent classifications outside of the United States.Bourns expressly identifies those Bourns standard products that are suitable for use in automotive applications on suchproducts’ data sheets in the section entitled “Applications.”
Unless expressly and specifically approved in writing by twoauthorized Bourns representatives on a case-by-case basis, use of any other Bourns standard products in an automotiveapplication might not be safe and thus is not recommended, authorized or intended and is at the user’s sole risk.
If Bournsexpressly identifies a sub-category of automotive application in the data sheet for its standard products (such as infotainmentor lighting), such identification means that Bourns has reviewed its standard product and has determined that if such Bourns standard product is considered for potential use in automotive applications, it should only be used in such sub-category ofautomotive applications. Any reference to Bourns standard product in the data sheet as compliant with the AEC-Q standardor “automotive grade” does not by itself mean that Bourns has approved such product for use in an automotive application.
Bourns standard products are not tested to comply with United States Federal Aviation Administration standards generallyor any other generally equivalent governmental organization standard applicable to products designed or manufactured foruse in aircraft or space applications.Bourns expressly identifies Bourns standard products that are suitable for use in aircraft or space applications on suchproducts’ data sheets in the section entitled “Applications.”
Unless expressly and specifically approved in writing by twoauthorized Bourns representatives on a case-by-case basis, use of any other Bourns standard product in an aircraft orspace application might not be safe and thus is not recommended, authorized or intended and is at the user’s sole risk.The use and level of testing applicable to Bourns custom products shall be negotiated on a case-by-case basis by Bournsand the user for which such Bourns custom products are specially designed.
w103 potentiometer – HOME PAGE